Avaya X330W2-DS1 Manual Do Utilizador

Configuring the X330WAN

Avaya X330W-2DS1 User’s Guide

27

Loopback. Verify that the output information is correct.

•

Use  the  "show running-config" command to display the configuration 
running on the switch. 

•

Use  the  "show startup-config" command to display the configuration 
loaded at startup.

•

Use  the  "ping" <host> [<interval> [<size>]] command to send 
ICMP echo request packets to another node on the network. Each node is 
periodically pinged and checked if an answer was received. This checks host 
reachability and network connectivity.

It is advisable to save your configuration. 

Your configurations are lost after each reset or after a power failure.

To save your configuration, type "copy running-config startup-config". This copies your X330WAN configuration from the current VRAM Running 
Configuration to the Startup Configuration NVRAM.

Perform the following steps to establish a Telnet connection to the X330WAN for 
configuration of WAN parameters. Telnet directly to one of the Router IP addresses:
1

Connect your station to the network.

2

Verify that you can communicate with the X330WAN using the 
"ping"

 <host> [<interval> [<size>]] command to the IP of the 

X330WAN. If there is no response, check the IP address and default gateway of 
both the X330WAN and the station.

3

From the Microsoft Windows

®

 taskbar of your PC, click Start and then Run (or 

from the DOS prompt of your PC), then start the Telnet session by typing: 
telnet

 <X330WAN_IP_address> 

For example: telnet 149.49.32.134

You can also Telnet the IP address of the P330 stack. If you Telnet the IP 

address of the stack, a connection is established with the Switch CLI entity of the 
Master module of the stack.
If you want to connect to the X330WAN CLI entity, use the "session" wan 
<module number in stack> 

command. 

4

When prompted for a Login Name, enter the default name root.