Avaya X330WAN Manual Do Utilizador

Controller CLI Commands (X330WAN-2DS1 Only)

Avaya X330WAN User’s Guide

117

The transmit attenuation value is best obtained by experimentation. If the 

signal received by the far-end equipment is too strong, reduce the transmit level by 
entering additional attenuation.

To set the transmit attenuation for a cable between 134 and 266 feet long:

X330WAN-2DS1-1(config-controller:1)# cablelength short 266ft

Use the

 channel-group 

command to create a channel group (also referred to as a 

"ds0 bundle"). A channel group can be the underlying interface for a PPP or Frame 
Relay session.
This command creates a logical interface, which is identified by a physical port 
number, a colon, and a channel group number. For example, channel group 8 on E1 
physical port 2 would be referred to as 2:8 in all places where a channel group is 
needed as a parameter.

 <channel-num> timeslots <timeslot-list

>  

 

{56 | 64}

The Speed option can be used only when the controller is set to T1.

If you have an active PPP or Frame Relay session over this channel group, a 

warning is issued.

channel-num

ID number to identify the channel group. The valid range is from 
0 to 23 for T1 lines, and from 0 to 30 for E1 lines.

timeslot-list

Timeslots (DS0s) to include in this channel group. The valid 
timeslots are: 
• 1 to 24 for T1. 
• 1 to 31 for E1.
Values can be either separated by a "," (to indicate a list) or a "-" 
(to indicate a range).

54 | 64

Acceptable speed values.