ZyXEL Communications NBG420N Manual Do Utilizador

 Chapter 7 Wireless LAN

NBG420N User’s Guide

1 Make sure the Wireless LAN on the NBG420N is enabled and that you know the 

security settings (if any). To do this check the Wireless LAN > General screen in the 
web configurator from your computer.

2 On the iPod Touch’s main screen press Settings > Wi-fi and from the list press the 

NBG420N’s network name (SSID) to connect to it. If you are prompted for any security 
settings enter them and press connect. If you cannot connect check your security settings 
in the web configurator from your computer and try again.

3 After connecting to the NBG420N’s wireless LAN network launch the iPod Touch 

Internet browser and enter the NBG420N’s IP address (default: 192.168.1.1) into the 
address bar. The login screen displays.

After accessing the NBG420N’s IP address in the iPod Touch web browser the screen below 
will display.

"

You cannot change your password in the iPod Touch web configurator. To 
change your password log into the web configurator using your computer.

Figure 73   Login Screen

The following table describes the labels in this screen.

Table 40   Login Screen

Auto Login

Select this checkbox to automatically log into the iPod Touch web configurator 

when accessing it through the same iPod Touch device.

Password

Enter the password for the NBG420N. If you haven’t changed the default 

password earlier this is “1234”.

Login

Press the Login button to log into the iPod Touch web configurator.

Reset

Press the Reset button to clear your selections and start over.