ZyXEL Communications NBG420N Manual Do Utilizador

 Chapter 3 Introducing the Web Configurator

NBG420N User’s Guide

Figure 5     Selecting the setup mode

If you forget your password or IP address, or you cannot access the web configurator, you will 
need to use the RESET button at the back of the NBG420N to reload the factory-default 
configuration file. This means that you will lose all configurations that you had previously 
saved, the password will be reset to “1234” and the IP address will be reset to “192.168.1.1”.

1 Make sure the power LED is on.
2 Press the RESET button for five seconds or until the power LED begins to blink and 

then release it. When the power LED begins to blink, the defaults have been restored and 
the NBG420N restarts.

The following summarizes how to navigate the web configurator from the Status screen in 
Router Mode and AP Mode. 

Click on Status. The screen below shows the status screen in Router Mode. 
(For information on the status screen in AP Mode see 

.)