ZyXEL Communications G-2000 Plus Manual Do Utilizador

ZyAIR G-2000 Plus User’s Guide

51 

Chapter 3 Wizard Setup

Figure 6   Wizard 2 : Wireless LAN Setup

The following table describes the labels in this screen.

Table 4   Wizard 2 : Wireless LAN Setup

Wireless LAN Setup

ESSID

Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the 

wireless LAN. 
If you change this field on the ZyAIR, make sure all wireless stations use the 

same SSID in order to access the network. 

Choose Channel ID

To manually set the ZyAIR to use a channel, select a channel from the drop-

down list box. Open the Channel Usage screen to make sure the channel is 

not already used by another AP or independent peer-to-peer wireless network. 

Security

The level of Security can be selected as none, basic or extended. Choose 

None security to have no wireless LAN security configured and proceed to the 

ISP Parameters for Internet Access screen. 
Choose Basic (WEP) security if you want to configure WEP Encryption 

parameters. 
Choose Extend (WPA-PSK) security to configure a Pre-Shared Key. 
The third screen varies depending on which security level you select.

Back

Click Back to return to the previous screen.

Next

Click Next to continue.

Note: The wireless stations and ZyAIR must use the same 
ESSID, channel ID and WEP encryption key (if WEP is 
enabled) or WPA-PSK (if WPA-PSK is enabled) for wireless 
communication

Choose Basic (WEP) security to setup WEP Encryption parameters.