ZyXEL Communications MES3500-24 Manual Do Utilizador
Chapter 13 Spanning Tree Protocol
MES3500-24/24F User’s Guide
138
13.8.1 Multiple Spanning Tree Protocol Port Configuration
To configure MSTP ports, click Port in the Advanced Application > Spanning Tree Protocol >
MSTP screen.
MSTP screen.
Figure 64
Advanced Application > Spanning Tree Protocol > MSTP > Port
The following table describes the labels in this screen.
Table 33
Advanced Application > Spanning Tree Protocol > MSTP > Port
LABEL
DESCRIPTION
Port
This field displays the port number.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Edge
Select this check box to configure a port as an edge port when it is directly attached to a
computer. An edge port changes its initial STP port state from blocking state to forwarding state
immediately without going through listening and learning states right after the port is configured
as an edge port or when its link status changes.
computer. An edge port changes its initial STP port state from blocking state to forwarding state
immediately without going through listening and learning states right after the port is configured
as an edge port or when its link status changes.
Note: An edge port becomes a non-edge port as soon as it receives a Bridge Protocol Data Unit
(BPDU).
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.