ZyXEL Communications 128L Manual Do Utilizador
Installation 17
The UTP port is used to connect to a 10Base-T network. 10Base-T
networks use Unshielded Twisted Pair (UTP) cable and RJ-45
connectors that look like a bigger telephone plug with 8 pins. Two types
of gray Ethernet cables come with the package:
networks use Unshielded Twisted Pair (UTP) cable and RJ-45
connectors that look like a bigger telephone plug with 8 pins. Two types
of gray Ethernet cables come with the package:
•
Straight through cable (white tag): Connect your Prestige 128L
to a 10Base-T hub.
to a 10Base-T hub.
•
Crossover cable (red tag): Connect your Prestige to your
computer directly without a hub.
computer directly without a hub.
O
N
OTE
:
I
F THIS CABLE IS USED TO CONNECT
IDSL,
IT MAY DAMAGE YOUR
P
RESTIGE
.
AUI
The AUI port (the connector with 15 pins) is used to connect your
Prestige to a 10Base5 (thicknet) network.
Prestige to a 10Base5 (thicknet) network.
If you have a 10Base2 network using BNC connectors and thin coaxial
cables, you will need a transceiver between the AUI port and the
10Base2 cabling.
cables, you will need a transceiver between the AUI port and the
10Base2 cabling.
Connecting the Power Adapter to your
Prestige
Prestige
Plug the 16VAC 1000mA power adapter into the outlet on the rear
panel of the Prestige labeled POWER.
panel of the Prestige labeled POWER.
At this point, you should have connected the RS-232 cable, the ISDN
phone line, the Ethernet cable, and the power supply. You can now
power on your Prestige.
phone line, the Ethernet cable, and the power supply. You can now
power on your Prestige.
Prestige Front Panel
Names and descriptions of the Prestige front panel LEDs are listed
below:
below: