ZyXEL Communications X6004 Manual Do Utilizador
Chapter 1 Getting to Know Your X6004
X6004 User’s Guide
36
• Write down the administrator password and put it in a safe place.
• Back up the configuration (and make sure you know how to restore it). Restoring an
• Back up the configuration (and make sure you know how to restore it). Restoring an
earlier working configuration may be useful if the device becomes unstable or even
crashes. If you forget your password, you will have to reset the X6004 to its factory
default settings. If you backed up an earlier configuration file, you would not have to
totally re-configure the X6004. You could simply restore your last configuration.
crashes. If you forget your password, you will have to reset the X6004 to its factory
default settings. If you backed up an earlier configuration file, you would not have to
totally re-configure the X6004. You could simply restore your last configuration.
1.4 LEDs
The figure below shows the LEDs on the X6004.
Figure 4 LEDs
The following table describes the LEDs.
PWR
ALM
WAN
LAN
SYS
HDD
SYS
FXS
SYS
FXO
1
2
3
4
1
2
3
4
Table 1 LEDs
LED
COLOR STATUS
DESCRIPTION
PWR
Green
On
The X6004 is turned on.
Off
The X6004 is off.
SYS
Green
Blinking
The X6004 is rebooting and performing self-diagnostic tests.
On
The X6004 is on and functioning properly.
Off
The power is off or the X6004 is not ready/malfunctioning.
ALM
Red
On
There is a hardware failure.
Off
The X6004 is functioning normally.
HDD
Green
Blinking
The X6004 is writing to the hard disk.
On
The hard drive is installed and recognized by the X6004.
Off
The X6004 does not have a hard drive installed.
Interface Card LEDs
SYS
Green
On
The interface card is functioning properly.
Off
The interface card is not recognized by the X6004.
FXS 1~4
Green
On
The line is in use.
Off
The line is not in use.
FX0 1~4
Green
On
The line is connected and receiving a signal.
Off
The line is not connected.