Black Box EME149D-20 Manual Do Utilizador
724-746-5500 | blackbox.com
Page 22
EME149A-20
724-746-5500 | blackbox.com
Chapter 3: Installation
To change the IP address of the ServSensor V4E Lite:
1. Select Ethernet network.
2. Input the new IP address.
3. Click the “Save” button.
3.2 Testing the New IP Address with the “Ping” Command
Once you assign the new IP address, use the “ping” command to test the ServSensor V4E Lite. You can also use this command as
a diagnostic tool to check whether your unit is connected to the network. See Figure 3-5.
a diagnostic tool to check whether your unit is connected to the network. See Figure 3-5.
1. Click “Start.”
2. Click “Run.”
3. Type “ping (IP address that the user entered),” and press Enter. An example IP address (10.1.5.206) is shown in Figure 3-5.
Figure 3-5. Ping Command screen.
4. After you press the “Enter” key, an MS-DOS
®
prompt window showing the test results appears (see Figure 3-6). If you get a
message saying “request timed out,” either the IP address is incorrect or a ServSensor V4E Lite is not connected to the
network.
network.