Cisco Systems 566 Manual Do Utilizador
Chapter 3 Installing the Content Engine
Installing a CE-511 or CE-566 Unit
3-2
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Angle brackets for mounting CE-511 and CE-566 units in a 2-post rack are also
included in your shipping container accessory box.
included in your shipping container accessory box.
You need the following parts and tools to install the Content Engine in a rack:
•
Flat-blade screwdriver
•
Phillips screwdriver
•
One rack-mount kit
•
Documentation
Installing a CE-511 or CE-566 Unit
Place the unit in the desired location. You can mount it in a rack for your
convenience, or place it on a solid, stable surface. If you do not plan to install the
unit in an equipment rack, proceed to the
convenience, or place it on a solid, stable surface. If you do not plan to install the
unit in an equipment rack, proceed to the
Racks are marked in vertical increments of 1.75 inches (4.44 cm). Each increment
is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.
is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
•
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
or servicing the unit in the rack.
Statement 1006