Kenwood KDC-X797 Manual Do Utilizador
#CAUTION
Use of controls or adjustments or
performance of procedures other than
those specified herein may result in
those specified herein may result in
hazardous radiation exposure.
In compliance with Federal Regulations,
In compliance with Federal Regulations,
following are reproductions of labels on, or
inside the product relating to laser product
inside the product relating to laser product
safety.
JVC KENWOOD Corporation
2967-3, ISHIKAWA-MACHI,
HACHIOJI-SHI, TOKYO, JAPAN
2967-3, ISHIKAWA-MACHI,
HACHIOJI-SHI, TOKYO, JAPAN
THIS PRODUCT COMPLIES WITH DHHS RULES
21 CFR SUBCHAPTER J IN EFFECT AT DATE OF
MANUFACTURE.
Location : Top plate
---------------------------------------------------------------
• Contains Transmitter Module
FCC ID : XQN-BTR60X
• Contains Transmitter Module
IC: 9688A-BTR601
---------------------------------------------------------------
CALIFORNIA, USA ONLY
This product contains a CR Coin Cell Lithium
Battery which contains Perchlorate Material –
special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/
perchlorate
This product contains a CR Coin Cell Lithium
Battery which contains Perchlorate Material –
special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/
perchlorate
FCC WARNING
This equipment may generate or use radio
frequency energy. Changes or modifications
to this equipment may cause harmful
to this equipment may cause harmful
interference unless the modifications
are expressly approved in the instruction
manual. The user could lose the authority to
manual. The user could lose the authority to
operate this equipment if an unauthorized
change or modification is made.
FCC NOTE
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment may cause harmful
reasonable protection against harmful
interference in a residential installation.
This equipment may cause harmful
interference to radio communications, if
it is not installed and used in accordance
it is not installed and used in accordance
with the instructions. However, there is
no guarantee that interference will not
no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
IC (Industry Canada) Notice
This device complies with Industry Canada
licence-exempt RSS standard(s).
Operation is subject to the following two
licence-exempt RSS standard(s).
Operation is subject to the following two
conditions:
(1)This device may not cause interference,
(1)This device may not cause interference,
and
(2)this device must accept any interference,
including interference that may cause
including interference that may cause
undesired operation of the device.
The term “IC: ” before the certification/
registration number only signifies that the
The term “IC: ” before the certification/
registration number only signifies that the
Industry Canada technical specification
were met.
were met.
#CAUTION
This equipment complies with FCC/IC
radiation exposure limits set forth for an
uncontrolled environment and meets
the FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65
uncontrolled environment and meets
the FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65
and RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment has very
low levels of RF energy that it deemed
to comply without maximum permissive
Exposure rules. This equipment has very
low levels of RF energy that it deemed
to comply without maximum permissive
exposure evaluation (MPE). But it is
desirable that it should be installed and
operated keeping the radiator at least
20cm or more away from person’s body
(excluding extremities: hands, wrists, feet
20cm or more away from person’s body
(excluding extremities: hands, wrists, feet
and ankles).
Under Industry Canada regulations, this
radio transmitter may only operate using
an antenna of a type and maximum (or
lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio
interference to other users, the antenna
type and its gain should be so chosen that
the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for
successful communication.
radio transmitter may only operate using
an antenna of a type and maximum (or
lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio
interference to other users, the antenna
type and its gain should be so chosen that
the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for
successful communication.
Note de IC (Industrie Canada)
Le présent appareil est conforme aux
CNR d’Industrie Canada applicables aux
CNR d’Industrie Canada applicables aux
appareils radio exempts de licence.
L’exploitation est autorisée aux deux
L’exploitation est autorisée aux deux
conditions suivantes :
(1) l’appareil ne doit pas produire de
(1) l’appareil ne doit pas produire de
brouillage, et
(2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d’en compromettre le fonctionnement.
d’en compromettre le fonctionnement.
L’expression “IC:” avant le numéro
d’homologation/ enregistrement signifie
d’homologation/ enregistrement signifie
seulement que les specifications techniques
d’Industrie Canada ont été respectées.
#ATTENTION
Cet équipement est conforme aux limites
d’exposition aux rayonnements énoncées
pour un environnement non contrôlé
et respecte les règles d’exposition aux
fréquences radioélectriques (RF) CNR-102
pour un environnement non contrôlé
et respecte les règles d’exposition aux
fréquences radioélectriques (RF) CNR-102
de l’IC. Cet équipement émet une énergie
RF très faible qui est considérée conforme
sans évaluation de l’exposition maximale
autorisée. Cependant, cet équipement
RF très faible qui est considérée conforme
sans évaluation de l’exposition maximale
autorisée. Cependant, cet équipement
doit être installé et utilisé en gardant une
distance de 20 cm ou plus entre le dispositif
rayonnant et le corps (à l’exception des
extrémités : mains, poignets, pieds et
chevilles).
extrémités : mains, poignets, pieds et
chevilles).
Conformément à la réglementation
d’Industrie Canada, le présent émetteur
radio peut fonctionner avec une antenne
d’un type et d’un gain maximal (ou
inférieur) approuvé pour l’émetteur par
Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectrique
à l’intention des autres utilisateurs, il faut
choisir le type d’antenne et son gain de
d’Industrie Canada, le présent émetteur
radio peut fonctionner avec une antenne
d’un type et d’un gain maximal (ou
inférieur) approuvé pour l’émetteur par
Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectrique
à l’intention des autres utilisateurs, il faut
choisir le type d’antenne et son gain de
B59-2185-00_00_K.indb 32
12/11/27 8:43