Benq W6500 Manual Do Utilizador
45
Additional information
Eng
lish
lish
Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp,
please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and
in some instances the lamp may explode. Go to
please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and
in some instances the lamp may explode. Go to
http://lamp.BenQ.com
for a replacement lamp.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn
the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after
turning the power back on, please contact your dealer. See
the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after
turning the power back on, please contact your dealer. See
for details.
The following Lamp warning displays will remind you to change the lamp.
Replacing the lamp
•
To reduce the risk of electrical shock, always turn the projector off and disconnect the power cable
before changing the lamp.
before changing the lamp.
•
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replacing
the lamp.
the lamp.
•
To reduce the risk of injuries to fingers and damage to internal components, use caution when
removing lamp glass that has shattered into sharp pieces.
removing lamp glass that has shattered into sharp pieces.
•
To reduce the risk of injuries to fingers and/or compromising image quality by touching the lens, do
not touch the empty lamp compartment when the lamp is removed.
not touch the empty lamp compartment when the lamp is removed.
•
This lamp contains mercury. Consult your local hazardous waste regulations to dispose of this lamp in
a proper manner.
a proper manner.
Status
Message
The lamp has been in operation for 2000 hours. Install a new lamp
for optimal performance. If the projector is normally run with
Economic selected (See
for optimal performance. If the projector is normally run with
Economic selected (See
you may continue to operate the projector until the 2980 hour lamp
warning appears.
warning appears.
Press ENTER to dismiss the message.
The lamp has been in operation for 2980 hours. It is strongly
recommended that you replace the lamp at this age. The lamp is a
consumable item. The lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp whenever you notice
that the brightness level has significantly diminished. If the lamp is
not replaced beforehand, it should be replaced after 2980 hours
usage.
recommended that you replace the lamp at this age. The lamp is a
consumable item. The lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp whenever you notice
that the brightness level has significantly diminished. If the lamp is
not replaced beforehand, it should be replaced after 2980 hours
usage.
Press ENTER to dismiss the message.
The lamp has been in operation for 3000 hours. The lamp MUST be
replaced before the projector will operate normally.
The lamp has been in operation for 3000 hours. The lamp MUST be
replaced before the projector will operate normally.
Press ENTER to dismiss the message.
OK
NOTICE: Order replacement lamp
Lamp > 2000hrs
Order a new lamp at
lamp.benq.com
lamp.benq.com
WARNING
OK
NOTICE: Replace lamp soon
Lamp > 2980hrs
Order a new lamp at
lamp.benq.com
lamp.benq.com
WARNING
NOTICE: Replace lamp now
Lamp > 3000hrs
Lamp-usage time exceeded
Replace lamp (refer to User’s Manual)
then reset lamp timer.
Order a new lamp at
lamp.benq.com
Replace lamp (refer to User’s Manual)
then reset lamp timer.
Order a new lamp at
lamp.benq.com
OK
WARNING