Runco DTV-1101 Manual Do Utilizador

Location and Function of Controls

2-1

5

1

2

V NOM
1 MAX
FREQ

120/230 Volt

7/5 Amp
50/60Hz

3

4

RS232 IN

RS232 OUT

IR

REMOTE

RS 232 Input Port
Connection between the projector and an IBM PC (or
compatible) or MAC (RS422) for remote computer control
and data communication.

RS 232 Output Port
RS 232 Output Port allows a communication link for PC or
MAC to the next projector in a series of projector.

IR Sensor
Receiver for control signals transmitted from the RCU.

IR Remote
Connector for remote input for hard wired remote control

Communication Port
* Not used.

Port 3
RGB Analog Input (9 pin female sub D connector): allows a
character generator, microcomputer, etc. having analog
RGB outputs to be connected to the projector.

Port 4/5 RGB-S Input  (5x BNC connector):

RGB-S input

 : allows a character generator, microcomputer,

video camera, etc. having analog RGB output to be con-
nected to the projector.

Line inputs:

- signals RED-GREEN-BLUE
- COMPOSITE sync signal
- Tri level sync signal (option)

Projector Mode: indicates the status of the projector.

- unlit: mains (power) switch is not pressed.
- lit: mains (power) switch is pressed and the indicated

color shows the projector mode:
Green:

operational mode of the projector.

Red:

standby mode of the projector.

Important: projector ("Operational" or "Standby") mode is
defined during the installation of the projector. (Refer to a
qualified technician for change).

Power Switch: press the switch to turn the projector ON.

Depending on the hardware set-up of the projector during
installation, the projector will switch to ‘Standby’ or to
‘Operational' mode.  If in standby, the standby LED will
light up.

5

1

2

3

4