Runco DTV-947 Manual Do Utilizador
2-1
LOCATION AND FUNCTION OF CONTROLS
RS 232 Input Port
Connection between the controller and projector. Connect the RS-
232 output from the controller to this port.
Connection between the controller and projector. Connect the RS-
232 output from the controller to this port.
RS 232 Output Port
RS 232 Input Port allows a communication link for PC or MAC to
the next projector in a series of projectors.
RS 232 Input Port allows a communication link for PC or MAC to
the next projector in a series of projectors.
IR Sensor
Receiver for control signals transmitted from the RCU.
Receiver for control signals transmitted from the RCU.
Communication Port -not used.
IR Remote
Connector for remote input for hard wired remote control
Connector for remote input for hard wired remote control
RGBHV or Component Input (5x BNC connector):
Connect the RGB output from the VHD controller here.
Connect the RGB output from the VHD controller here.
Line inputs:
-signals RED-GREEN-BLUE
-Horizontal and Vertical Sync
-If using Composite Sync, connect it to ‘H’.
-Horizontal and Vertical Sync
-If using Composite Sync, connect it to ‘H’.
(R-Y)Y(B-Y)-S Input (component input): allows to connect e.g. a
DTV Decoder having component outputs to the projector.
DTV Decoder having component outputs to the projector.
Line inputs
-signals RED-LUMA, LUMA, BLUE-LUMA
1
2
3
4
5
6
VIDEO Input (Composite video, 1x BNC connector):
Allows a video tape recorder, video camera, color receiv-
er/monitor, etc. having video line output to be connected
to the projector.
Allows a video tape recorder, video camera, color receiv-
er/monitor, etc. having video line output to be connected
to the projector.
S-VIDEO Input: Separated Y/C (luma-chroma) signal
inputs and outputs for higher quality playback of DVD
signals (4-pin S-VIDEO connector loop-through).
inputs and outputs for higher quality playback of DVD
signals (4-pin S-VIDEO connector loop-through).
7
8
RS232 IN
RS232 OUT
IR
COMM PORT
REMOTE
R
G(s)
B H V VIDEO S - VIDEO
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
1
2
3
4
5
6
7
8