Ricoh PJ WX3231N Manual Do Utilizador

7

When the beep sound setting is [

On], the projector beeps, and a message appears, 

confirming that you wish to shut off the power. To shut off the power, press the ON/
STANDBY button again. If you do not wish to shut off the power, wait for a while without 
conducting any operations. The message will disappear after a moment and the 
operation will no longer be valid.

When the beep sound setting is [

On], the projector 

beeps, and the screen disappears, but the internal 

cooling fan continues to operate. The projector will 

then go into standby mode.

During cooling, the ON/STANDBY indicator flashes. 

While the indicator is flashing, the power cannot be 

turned back on. There is no problem with unplugging 

the power cord in this state.

After use, replace the lens cap.

The projector consumes about 4.5 W of power in standby. We recommend that you 
unplug the power cord if you will not be using the projector for an extended period. 
When [

Network standby] is [On], it consumes about 8 W during standby.

    

If you wish to restart the projector again right after turning off the power, give the lamp 
time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it may 
fail to light.
Right after turning off the power, the unit may become very hot, especially the air 
exhaust, lamp cover or bottom of the unit. Please handle with care to avoid burn injuries.



•

•

•