Sanyo PLC-XE50 Manual Do Utilizador

This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of the plug. 
Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating, marked thus 

. If the fuse 

cover is detachable, never use the plug with the cover omitted. If a replacement fuse cover is required, ensure it is of the same 
colour as that visible on the pin face of the plug (i.e. red or orange). Fuse covers are available from the Parts Department indicated 
in your User Instructions.
If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.
The end of the flexible cord should be suitably prepared and the correct plug fitted.

The Wires in this mains lead are coloured in accordance with the following code:

Green-and-yellow ············ Earth
Blue ································· Neutral
Brown ······························ Live

As  the  colours  of  the  wires  in  the  mains  lead  of  this  apparatus  may  not  correspond  with  the  coloured  markings  identifying  the 
terminals in your plug proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or by 
the safety earth symbol   or coloured green or green-and-yellow.

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.  

AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL) and 
certified by the Canadian Standard Association (CSA).
AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug will fit 
into the power outlet. Do not try to defeat this safety feature. Should you be unable to insert the plug into 
the outlet, contact your electrician.

GROUND

This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  B  digital  device,  pursuant  to  Part  15  of  the 
FCC  Rules. These  limits  are  designed  to  provide  reasonable  protection  against  harmful  interference  in  a  residential  installation. 
This  equipment  generates,  uses,  and  can  radiate  radio  frequency  energy.  If  it  is  not  installed  and  used  in  accordance  with  the 
instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures:
–  Reorient or relocate the receiving  antenna.
–  Increase the separation between the equipment and receiver.
–  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–  Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of FCC Rules.
Do  not  make  any  changes  or  modifications  to  the  equipment  unless  otherwise  specified  in  the  instructions.  If  such  changes  or 
modifications should be made, you could be required to stop operation of the equipment.
Model Number(s)  

: PLC-XE50

Trade Name  

 

: Sanyo

Responsible party  

: SANYO FISHER COMPANY

Address  

 

: 21605 Plummer Street, Chatsworth, California 91311

Telephone No.   

: (818)998-7322