Sanyo PLC-XP100BKL Manual Do Proprietário

Turning On the Projector

Connect the projector’s AC power cord into an AC

outlet. The LAMP indicator lights red and the POWER

indicator lights green.
Press the ON/STAND-BY button on the side control

or the ON button on the remote control. The LAMP

indicator dims and the cooling fans start to operate.

The preparation display appears on the screen and the

countdown starts.

The preparation display will disappear after 30

seconds.

After the countdown, the input source that was

selected the last time and the Lamp control status icon

(see page 51) appear on the screen.

If the projector is locked with a PIN code, PIN code

Input Dialog Box will appear. Enter the PIN code as

instructed below.

Selected Input Source and Lamp control

Complete peripheral connections (with a computer,

VCR, etc.) before turning on the projector.

What is PIN code?
PIN (Personal Identification Number) code is a security

code that allows the person who knows it to operate the

projector. Setting a PIN code prevents unauthorized use of

the projector.

A PIN code consists of a four-digit number. Refer to the PIN

code lock function in the Setting Menu on page 53-54 for

locking operation of the projector with your PIN code.

PIN code Input Dialog Box

Enter a PIN code

CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector

can no longer be started. Take special care

in setting a new PIN code; write down the

number in a column on page 76 of this

manual and keep it at hand. Should the

PIN code be missing or forgotten, consult

your dealer or service center.

After the OK icon

disappears, you can

operate the projector.

Lamp control status

See page 51 for the Lamp control status

✔

Note:

• The Lamp replacement icon and the Filter

replacement or the Filter cartridge replacement
icon may appear on the screen depending on the
usage state of the projector.

• When the filter cartridge replacement icon

keeps appearing on the screen at turning on the
projector for some time and no action is taken
to replace the filter cartridge, the projector will
be automatically shut down in 3 minutes after
turning on to protect the projector. (pp. 56-58, 70)

Use the Point

buttons on the side control or Number

buttons on the remote control to enter a number.

When using side control

Use the Point

buttons on the side control to select a

number. Press the Point

button to fix the number and

move the red frame pointer to the next box. The number

changes to “✳.” Repeat this step to complete entering a

four-digit number. After entering the four-digit number, move

the pointer to “Set.” Press the SELECT button so that you

can start to operate the projector.

When using remote control

Press the Number buttons on the remote control to enter

a number (p.14). When you complete entering a four-digit

number, the pointer moves to “Set.” Press the SELECT

button so that you can start to operate the projector.

If you fixed an incorrect number, use the Point

button to

move the pointer to the number you want to correct, and

then enter the correct number.

If you entered an incorrect PIN code, “PIN code” and the

number (✳✳✳✳) will turn red for a moment. Enter the

correct PIN code all over again.

✔

Note:

• When the Logo select function is set to “Off,” the

logo will not be shown on the screen (p.49).

• When the “Countdown off” or “Off” is selected

in the Display function, the countdown will not
be shown on the screen (p.48).

• During the countdown period, all operations are

invalid.

• If the correct PIN code number is not entered

within three minutes after the PIN code dialog
box appeared, the projector will be turned off
automatically.

• The “1234” is set as the initial PIN code at the

factory.

Basic Operation