Sanyo PLC-XU355A Manual Do Utilizador

– Check PC adjust menu or Screen menu and adjust them.

See pages 33-34, 37-38 .

   

– PIN code lock is being set. Enter a PIN code ("

13" or numbers

 

 you have set). See pages 21, 56-57.

– Make sure your computer is connected to the projector with USB

  cable. See page 16.  

 

– Check cable connection between the projector and your computer.

 

 See page 16.

   

– Check the batteries.

 

– Make sure no obstruction is between the projector and remote

 

control.

 

– Make sure you are not too far from the projector when using the

 

 remote control. Maximum operating range is 16.4'(5 m).

– Make sure the code of the remote control is conformed to the  

 

projector’s code. See page 55

 

– Unlock the Key lock function for the remote control function. See

 

 page 56.

 

– Check RESET/ON/ALL-OFF switch on the remote control is set to

“ON”. See page 13.

– Check the status of the projector with referring to "

  projector Condition". See page 72.  

 

  

– Check the connection between the projector and your computer.

– Check the mouse setting on you computer.

 

– Make sure the mouse driver is installed on your computer,

 

 otherwise, the remote control can not be used as a wireless mouse.

 

– Make sure the signal is from the computer, otherwise, the remote

 

 control can not be used as a wireless mouse.  

 

– Turn on the projector before turning on the computer.

 

– Your operation is invalid. Operate correctly.

                                                                 – The top control is not available if the top control is locked at Key lock

 

under

Security of SETTING section. See page 56.

 

– Contact the dealer where you purchased the projector or the service

 

 center.