Sanyo PLC-WXL46 Manual Do Utilizador

Follow these steps to replace the lamp.

Lamp

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following

information to the dealer.

●

●

(Service Parts No. 610 332 3855)

For continued safety, replace with a lamp of the

same type. Do not drop a lamp or touch a glass

bulb! The glass can shatter and may cause injury.

Allow the projector to cool for at least 45 minutes

before you open the Lamp cover. The inside of the

projector can become very hot.

Screw

Turn off the projector and unplug the AC power cord.

Let the projector cool for at least 45 minutes.

Loosen the two screws that secure the lamp. Lift the

lamp out of the projector by using the built in handle.

Replace the lamp with a new one and secure it with the

two screws. Make sure that the lamp is set properly.

Put the lamp cover back and secure it with the screw.

Turn the projector over. Remove the screw that

secures the lamp cover, and then open the lamp cover.

Connect the AC power cord to the projector and turn

on the projector.

See “Lamp Replacement Counter” on the next page.

Handle

Screw

Screw

Lamp Cover

When the projection lamp of the projector reaches the end

of its life, the LAMP REPLACE indicator emits a yellow light.

If this indicator lights yellow, replace the lamp with a new

one promptly.

WARNING: 

TURN OFF THE UV LAMP BEFORE

OPENING THE LAMP COVER

This indicator

turns yellow

when the

projection lamp

reaches the end

of its life.



The Lamp replacement icon will not appear

when the Display function is set to “Off” (p.41),

during “Freeze” (p.23), or “No show” (p.24).