Sanyo PLC-WL2503A Manual Do Utilizador

This function detects the input signal automatically. When

a signal is found, the search will stop. Use the Point

▲▼

 

buttons to select one of the following options.

  Off ......... Input search does not work.

  On 1....... Input search works under the following situation.

– When  pressing  the AUTO  SET  button  on  the

remote control.

  On 2....... Input search works under the following situation.

– When turning on the projector by pressing the

ON/STAND-BY button.

– When pressing the AUTO SET button on the

remote control.

– When the current input signal is cut off.*

*

 

If the No show or Freeze function is active, cancel

it to activate the Input search. It is also unavailable

when On-Screen Menu is displayed.

  On. . . . . . .Enables Auto  PC  adjustment  when  pressing

the AUTO SET button on the remote control.

  Off  . . . . . .Disables Auto PC adjustment.



 • While Input search function is set to

On 1 or On 2, the status of Input and Lamp are displayed every time the

signal is switched.

 • Only the last selected input source can be detected.

 • If the COMPUTER 1/2 button, VIDEO, S-VIDEO, COMPONENT or HDMI button on the remote control is

pressed during Input search is in progress, Input search will stop and go back to the previous input signal.

 • Auto PC adj. and Input search functions can not be set

Off at the same time.

 •

Fine sync, Total dots, Horizontal and Vertical positions of some computers can not be fully adjusted

with the Auto PC adjustment function. When the image is not provided properly with this operation, manual

adjustments are required (pp.31-32).

This function enables Input search and Auto PC adjustment by

pressing the AUTO SET button on the remote control. Settings

for those functions can be altered as follows: