Sanyo 1AV4U19B25500 Manual Do Utilizador

Error Screen

With this setting, you do not need any complicated LAN setting procedures.  
The network type will be AdHoc mode.

CAUTION: This function can be used only when logged in by Administrative right with
 

Windows XP and Windows Vista, and cannot be used with Windows 2000.

 

Windows XP should be Service Pack 1 or later version. 

1. Turn on the projector and select “Network” in the Input menu of the projector.
2. Select “LAN mode select” in the Network menu, and press SELECT button.
3. Select “Wireless Simple” with the Point ed buttons. Press SELECT button then the “Please wait...” 

message  will  appear  and  switching  operation  will  start.  Switching  will  take  a  while  and  after 
completing the operation the message “Ready for use” will appear. During the switching period, the 
projector cannot be operated. (“SIMPLE” LAN settings will be shown by pressing SELECT button. The 
settings cannot be changed.)

4. Activate “Network Capture 5” which is installed in the computer.
5. Click Wireless easy setting button on the operation screen. The Wireless LAN setting screen will 

appear  and  the  computer  will  start  to  set  up  the Wireless  LAN  setting.  (Adjust  the  computer’s 
Wireless LAN environment to the “SIMPLE” setting LAN environment.)

  After completing the settings, the computer will start searching the projector which was set as 

“SIMPLE” and will display the name of the projector or the IP address on the projector list.

  Confirm  whether  the  LAN  has  been  set  correctly  and  works  properly.  Refer  to “4. Wired  LAN 

configurations” ➔ “Confirming the operation” (p.30) for the confirmation procedures.

  If the network setup is not succeeded, the error screen will appear.

Wireless easy setting button

Setting screen