Sanyo 1080HD Manual Do Utilizador

When the projection lamp of this projector reaches its end of life, 
the LAMP REPLACE indicator emits yellow light. If this indicator 
lights yellow, replace the lamp with a new one promptly.
The time when the LAMP REPLACE indicator should light is 
depending on the lamp mode.

Follow these steps to replace the lamp.

Lamp

Lamp Cover

  Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information 

to the dealer.

 

●

 

 

 

●

 

 

       

   

 

 

(Service Parts No. 610 336 5404)

For continued safety, replace the lamp with the same 
type lamp. Do not drop the lamp or touch the glass 
bulb! The glass can shatter and may cause injury.

Allow the projector to cool, for at least 45 minutes 
before you open the lamp cover. The inside of the 
projector can become very hot.

Screw

Turn off the projector and unplug the AC power cord. Let the 
projector cool for at least 45 minutes.

Loosen the two (2) screws that secure the lamp. Pull out the 
lamp by using the built in handle.

Replace the lamp with a new one and secure it with the two 
(2) screws. Make sure that the lamp is set properly. Put the 
lamp cover back and secure it with the screw.

Loosen the screw that secures the lamp cover, and then 
open the lamp cover.

Connect the AC power cord to the projector and turn on the 
projector.

Reset the Lamp replacement counter (p.50).

Handle

Screws

This indicator lights yellow 
when the projection lamp 
reaches its end of life.