Sanyo PLC-XTC50AL Manual Do Utilizador

The WARNING indicators show the state of the function which protects the projector. Check the state of the 

WARNING indicators and the POWER indicator to take proper maintenance. 

When the temperature inside the projector reaches a 

certain level, the projector will be automatically shut 

down to protect the inside of the projector. The POWER 

indicator is blinking while the projector is being cooled 

down. When the projector has cooled down enough (to its 

normal operating temperature), it can be turned on again by 

pressing the ON/STAND-BY button.

✔

Then check the matters below:
–  Did you provide appropriate space for the projector to be 

ventilated? Check the installing condition to see if the air 

vents of the projector are not blocked.

–  Has the projector been installed near an Air-Conditioning/ 

Heating Duct or Vent? Move the installation of the 

projector away from the duct or vent.

–  Is the filter clean? Clean the filter periodically or replace it 

with a new one.

When the projector detects an abnormal condition, it will 

be automatically shut down to protect the inside of the 

projector and the WARNING TEMP. indicator lights red.  In 

this case, unplug the AC power cord and plug it, and then 

turn on the projector once again to verify operation. If the 

projector cannot be turned on and the WARNING TEMP. 

indicator lights red, unplug the AC power cord and contact 

the service station.

DO NOT LEAVE THE PROJECTOR WITH THE 

AC POWER CORD CONNECTED UNDER AN 

ABNORMAL CONDITION. IT MAY RESULT IN FIRE 

OR ELECTRIC SHOCK.