Sanyo PDG-DHT8000L Manual Do Utilizador

The WARNING indicators show the state of the function which protects the projector. Check the state of the 

WARNING TEMP. indicator and the LAMP indicator to take proper maintenance. 

When the temperature inside the projector reaches a 

certain level, the projector will be automatically shut down 

to protect the inside of the projector. The LAMP indicator 

turns red brighter and the WARNING TEMP indicator 

blinks while the projector is being cooled down. When the 

projector has cooled down enough (to its normal operating 

temperature), it can be turned on again by pressing the ON/

STAND-BY button.

✔

Then check the matters below:
–  Did you provide appropriate space for the projector to be 

ventilated? Check the installing condition to see if the air 

vents of the projector are not blocked.

–  Has the projector been installed near an Air-Conditioning/ 

Heating Duct or Vent? Move the installation of the 

projector away from the duct or vent.

–  Is the filter clean? Replace the filter with a new one.

DO NOT LEAVE THE PROJECTOR WITH THE 

AC POWER CORD CONNECTED UNDER AN 

ABNORMAL CONDITION. IT MAY RESULT IN FIRE 

OR ELECTRIC SHOCK.

When the projector detects an abnormal condition, it 

will be automatically shut down to protect the inside of 

the projector and the LAMP indicator lights on and other 

indicators blink. In this case, unplug the AC power cord and 

plug it, and then turn on the projector once again to verify 

operation. If the projector cannot be turned on and these 

indicators are still lighting and blinking, unplug the AC power 

cord and contact the service center.