Vidikron Vision 15 Manual Do Utilizador
34
Vidikron Vision Model 15 Installation/Operation Manual
3.
Secure the lens (with the mounting bracket attached) to the Lens Base Plate (6) using the
swell latches.
swell latches.
Adjusting the Lens Height and Angle:
1.
Project a white field on the screen.
2.
Loosen the four Height/Pitch Adjustment Screws just enough to allow vertical
movement of the lens assembly.
movement of the lens assembly.
3.
Slowly move the anamorphic lens into place so that there are no shadows on the top or
bottom of the screen:
bottom of the screen:
4.
Then, adjust the anamorphic lens angle so that the projected image is rectangular:
The anamorphic lens will almost always be angled with respect to the projector; this is
normal.
normal.
5.
When the height and angle are properly set, tighten the Height/Pitch Adjustment
Screws to secure the lens in place.
Screws to secure the lens in place.
To avoid clipping the corners of the image, position the anamorphic lens
as close as possible to the primary lens.
as close as possible to the primary lens.
There may be some pincushion distortion even after the lens is properly
adjusted, especially at shorter throw distances. If this is the case, Vidikron
recommends that you slightly over-scan the image into the screen frame
area to mask the distortion.
adjusted, especially at shorter throw distances. If this is the case, Vidikron
recommends that you slightly over-scan the image into the screen frame
area to mask the distortion.
Tip
Too High
Too Low
Correct position
Correct Lens Angle
Incorrect Lens Angle
Note