EIKI LC-WUL100L Manual Do Utilizador

Appendix

This projector provides a function to control and monitor the projector's operations by using the RS-232C

serial port.

Connect a RS-232C serial cross cable to CONTROL

PORT on the projector and serial port on the PC.

(See p.19)
Launch a communication software provided with PC

and setup the communication condition as follows:

Baud rate : 9600 / 19200 bps

Parity check

: none

Stop bit

: 1

Flow control

: none

Data bit

: 8

Type the command for controlling the projector and

then enter the "Enter" key.
Example

When you want to change the input to INPUT 2,

Type 'C' '0' '6' 'Enter'.



Note:

Enter with ASCII 64-byte capital

characters and one-byte characters.



Note:

The default of the baud rate is set to

19200 bps. If an error occurs in the

communication, change the serial port

and the communication speed (baud

rate).

Serial Control Interface

Operation

List of Picture in Picture

o : Picture in Picture combinations are enabled.

x : Picture in Picture combinations are disabled.



Note:

• When the input signal(s) is/are incompatible,

X mark will be displayed on the Main/Sub picture.

• Depending on the frequency or signal type of PC/AV input, the display resolution may be lowered

or images may not be displayed on the Main/Sub picture.

• Inputting PC analog signals: Between 100-160 MHz

• Inputting PC analog signals: More than 160 MHz

• Inputting PC digital signals: More than 100 MHz

• Inputting AV digital signals: 1080p

• Inputting signal formats: WUXGA 1, WXGA+2, UXGA 1, UXGA 2, UXGA 3, UXGA4, D-1080p

DVI