EIKI LC-WUL100L Manual Do Utilizador

  This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on 

the pin face of the plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must 

be used of the same rating, marked thus 

. If the fuse cover is detachable, never use the plug with the 

cover omitted. If a replacement fuse cover is required, ensure it is of the same colour as that visible 

on the pin face of the plug (i.e. red or orange). Fuse covers are available from the Parts Department 

indicated in your User Instructions.

  If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.

  The end of the flexible cord should be suitably prepared and the correct plug fitted.  
  WARNING: A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE 

  The Wires in this mains lead are coloured in accordance with the following code:

    Green-and-yellow ············· Earth

    Blue ······························ Neutral

    Brown ···························· Live

  As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured 

markings identifying the terminals in your plug proceed as follows:

  The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is 

marked by the letter E or by the safety earth symbol   or coloured green or green-and-yellow.

  The wire which is coloured blue must be connected to the terminal which is marked with the letter N or 

coloured black.

  The wire which is coloured brown must be connected to the terminal which is marked with the letter L 

or coloured red.

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.  

   AC Power Cord used in the United States and Canada is listed by the Underwriters 

Laboratories (UL) and certified by the Canadian Standard Association (CSA).

   AC Power Cord has a grounding-type AC line plug.  This is a safety feature to be 

sure that the plug will fit into the power outlet. Do not try to defeat this safety feature. 

Should you be unable to insert the plug into the outlet, contact your electrician.

GROUND

Federal Communications Commission Notice
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is encouraged to try to correct 

the interference by one or more of the following measures:

  – Reorient or relocate the receiving antenna. 

  – Increase the separation between the equipment and receiver. 

  – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

  – Consult the dealer or an experienced radio/TV technician for help.

Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.

Do  not  make  any  changes  or  modifications  to  the  equipment  unless  otherwise  specified  in  the 

instructions. If such changes or modifications should be made, you could be required to stop operation of 

the equipment.
Model Number  

: LC-WUL100, LC-WUL100L

Trade Name  

: EIKI 

Responsible party   : EIKI International,Inc. 

Address  

: 30251 Esperanza Santa Margaria CA 92688-2123

Telephone No.  

: 800-242-3454 (949-457-0200)

9