Infocus IN3926 Manual Do Utilizador

Página de 51
12
Shutting down the projector
Auto Off Time
The projector also has an Auto Off Time feature that automatically turns the 
projector off after no active sources are detected and no user interaction with the 
projector is performed for 30 minutes. By default, this feature is off. You can 
change the length of time, see page 29.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp 
turns off and the Power LED blinks blue for 1 minute while the fans continue to run 
to cool the lamp. If the Power Saving Mode feature is on and when the lamp has 
cooled, the LED lights blue and the fans stop. If the Power Saving Mode feature is 
off and when the lamp has cooled, the LED blinks blue and the fans stop. Unplug 
the power cable to completely power off the projector.
Troubleshooting your setup
If your image appears correctly on the screen, skip to the next section. If it does not, 
troubleshoot the setup.
The Status Indicator Panel on top of the projector indicates the state of the projector 
and can help you troubleshoot.
Table 3: Status indicator light behavior and meaning
Status Indicator Light
Meaning
POWER: Solid blue
POWER: Blinking blue
1. If the Power Saving Mode feature is on, 
the projector is plugged in.
2. The projector is on and initialized.
3. The projector is in normal operation.
1. If the Power Saving Mode is off, the 
projector is plugged in.
2. The projector is powering down and the 
fans are cooling the projector.
POWER: Blinking blue
TEMP: Blinking red
LAMP: Blinking red
POWER: Solid blue
TEMP: Blinking red
LAMP: Blinking red
The projector fan(s) are not operating 
correctly and the projector has been shut 
down.
The lamp failed to ignite.
Contact Technical Support if the problem 
persists. Visit www.infocus.com/support to 
contact service.
POWER: Solid blue
TEMP: Off
LAMP: Blinking red
The lamp has reached its end of life and 
must be replaced. The lamp will continue 
to operate until it fails.
Contact Technical Support. Repair may be 
needed.
POWER: Solid blue
TEMP: Blinking red
LAMP: Off
1. The projector is overheating and the 
lamp will be shut off. The fans will 
continue to run.
2. The projector will not turn back on until 
the cooling process is complete.