Thermador WD30 Manual Do Utilizador

English 6

1. Pull drawer to fully open position.
2. Press down right drawer clip.
3. Lift up left drawer clip.
4. Firmly pull the drawer straight out. Retract cabinet rails 

while drawer is removed.

1. Be sure cabinet rails are pushed inside cabinet.
2. Align the drawer rails with the cabinet rails.
3. Firmly push the drawer straight into the cabinet until 

drawer clicks into place.

4. Open and close drawer to test operation. Note: if the 

drawer will not close, verify that the rail clips are 
properly positioned.

Drawer interior (polished 
stainless steel)

Use dish detergent. 
Wash, rinse well and dry. 
For hard water spots or 
scale, use white vinegar. 
Apply with a sponge or 
cloth, rinse, and dry.
Heat Discoloration/
Corrosion: Clean with 
Bar Keeper‘s Friend® 
sprinkled on a wet 
sponge or wet cloth and 
applied to the wet 
stainless steel surface. 
Rub gently and evenly in 
the direction of the grain. 
Rinse and dry.

Painted surfaces

Use hot soapy water or 
mild cleaners such as 
Fantastik

 or Formula 

409

Wash, rinse well 

and dry. Avoid using 
abrasive cleaning 
agents, steel wool pads 
and oven cleaners.

Drawer exterior frame 
(brushed stainless steel)

Always wipe or rub in the 
direction of the grain. 
Clean with a soapy 
sponge, then rinse and 
dry, or wipe with 
Fantastik® or Formula 
409® sprayed on a 
paper towel. Protect and 
polish with Stainless 
Steel Magic® and a soft 
cloth. Remove water 
spots with a cloth 
dampened with white 
vinegar.

Warming Drawer Control

Clean with hot soapy 
water or apply 
Fantastik® or Formula 
409® to a clean sponge 
or paper towel and wipe 
clean. Avoid using 
abrasive cleaners and 
scrubbing pads.

To prevent burns, do not remove drawer 
while hot. Be sure drawer is empty before 
removing.

Low

High

_

Med

Proo

f

+

On/Off