ICOM IF6061 Manual Do Utilizador
6
1
PANEL DESCRIPTION
1
TX CODE ENTER KEY (PMR or BIIS PMR operation only)
Push to enter the ID code edit mode directly, for both 5-tone
and MSK. Then set the desired digit using [CH Up]/
[CH Down]. (p. 11)
Push to enter the ID code edit mode directly, for both 5-tone
and MSK. Then set the desired digit using [CH Up]/
[CH Down]. (p. 11)
TX CODE CHANNEL SELECT KEY
➥ Push to enter the ID code channel selection mode directly.
➥ Push to enter the ID code channel selection mode directly.
Then set the desired channel using [CH Up]/[CH Down].
(p. 10)
(p. 10)
➥ During ID code channel selection mode, push for 1 sec. to
enter the ID code edit mode for 5-tone and MSK. Then set
the desired digit using [CH Up]/[CH Down]. (p. 11)
the desired digit using [CH Up]/[CH Down]. (p. 11)
TX CODE CHANNEL UP/DOWN KEYS
➥ Push to select a TX code channel directly.
➥ Push to select a TX code channel directly.
➥ Push to set the desired digit during the ID code edit mode.
ID-MR SELECT KEY (PMR or BIIS PMR operation only)
➥ Recalls detected ID codes.
➥ Recalls detected ID codes.
• Push this key, then select the ID code using [CH Up]/[CH Down].
• Up to 5 ID’s are memorized.
• Up to 5 ID’s are memorized.
➥ Push and hold for 1 sec. to erase the selected ID’s.
HOOK SCAN KEY
When the on hook scan function is activated, push this key
to disables on hook scan function (stop scanning) temporari-
ly. Push this key again to re-start scanning.
When the on hook scan function is activated, push this key
to disables on hook scan function (stop scanning) temporari-
ly. Push this key again to re-start scanning.
USER SET MODE KEY
➥ Push and hold to enter user set mode.
➥ Push and hold to enter user set mode.
• During user set mode, push this key to select an item, and
change the value or condition using push [CH Up]/[CH Down].
➥ Push and hold this key again to exit user set mode.
User set mode is also available via the ‘Power ON function.’
Refer to p. 14 also.
User set mode is also available via the ‘Power ON function.’
Refer to p. 14 also.
MR-CH ENT KEYS
Push to enter the memory channel selection mode, then enter
the desired channel number using the 10-keypad of the con-
nected microphone.
Push to enter the memory channel selection mode, then enter
the desired channel number using the 10-keypad of the con-
nected microphone.
OPT 1/2/3 KEYS
Push to control the output signal level from the optional unit
connector.
Push to control the output signal level from the optional unit
connector.
IC-F5061_F6061_0.qxd 07.4.9 0:59 PM Page 6 (1,1)