Toshiba B-SV4D-QM Manual Do Utilizador

ENGLISH VERSION EO1-33035 

2.2 Procedure before Operation

E2- 2 

 

Operation 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This section describes the outline of the printer setup. 

  Unpack the accessories and printer from the box. 

  Refer to Safety Precautions in this manual and set up the printer at a 

proper location. 

  Make sure that the Power Switch is off. (Refer to Section 2.3.)

  Connect the printer to a host computer with an RS-232C, Centronics 

interface, or USB cable. (Refer to Section 2.4.) 

 Connect the Power Adapter to the printer, and then plug the Power 

Cord into a properly grounded power outlet. (Refer to Section 2.5) 

  Load the media. (Refer to Section 2.6.) 

  Adjust the position of the Feed Gap Sensor or Black Mark Sensor to 

match the media being used. (Refer to Section 2.7.) 

  Turn the Power ON. (Refer to Section 2.3.) 

 Install the Printer Drivers.  (Refer to the Printer Driver in the CD-

ROM.) 

 
 
 
 
 
 

When the printer is connected to a host computer it is good practice to 
turn the printer ON before turning on the host computer and to turn OFF 
the host computer before turning off the printer. 
 

  To turn ON the printer power, press the power switch as shown in the 

diagram below.  Note that (  ) is the power ON side of the switch. 

 

 

 

 

 

 

 

 

 

  Check that the Indicator Lamp is illuminated in green. 

 

Use the power switch to 
turn the printer On/Off.  
Plugging or unplugging the 
power cord to turn the 
printer On/Off may cause 
fire, an electric shock, or 
damage to the printer. 

 

Power Switch