Toshiba 3511 Manual Do Utilizador

November 2003  ©  TOSHIBA TEC

3 - 81

e-STUDIO3511/4511 ADJUSTMENT

ON

1

2

3

4

5

6

7

8

ON

1

2

3

4

5

6

7

8

A4 paper

LT paper

Perform this adjustment after replacing the finisher controller PC board or when the alignment position

must be changed for some reason.

(1)

Remove the rear cover of the finisher unit.

(2)

Check that the power is OFF and set SW104 on the finisher controller PC board as follows

according to the paper used for adjustment.

(3)

Turn ON the power.

(4)

Press SW103 on the finisher controller PC board.

• When SW103 is pressed, the swing guide opens and the alignment plate moves to prescribed

position.

(5)

Place ten sheets of A4/LT paper between the alignment plates and push them against the

stopper.

(6)

Press SW101 or SW102 on the finisher controller PC board and push the alignment plate against

the paper.

• When SW101 is pressed, alignment plate moves 0.42 mm forward.

• When SW102 is pressed, alignment plate moves 0.42 mm backward.

(7)

When adjustment is complete, remove paper and press SW103 on the finisher controller PC

board once to store the adjustment in memory.

(8)

Turn OFF all bits of finisher controller PC board SW104.

(9)

Turn OFF the power and install the rear cover of the finisher unit.