Toshiba 3511 Manual Do Utilizador

e-STUDIO3511/4511 ADJUSTMENT

3 - 84

November 2003  ©  TOSHIBA TEC

The folding position is adjusted by changing setting of bits 6 through 8 of SW504 on the saddle stitcher

controller PC board to match the stitching position (adjusting the distance over which the paper positioning

plate is moved to the folding position from the stitching position).

If you have replaced the saddle stitcher controller PC board, be sure to set the new SW504 so that the

settings will be the same as those on the old SW504. Perform this adjustment if, for any reason, you

must change the folding position.

(1)

Check that the power is OFF and separate the finisher from the host machine.

If the optional puncher unit is installed, remove it from the finisher.

(2)

Remove the PC board cover and set bits 1 through 4 of SW504 on the saddle stitcher controller

PC board as follows:

ON

1

2

3

4

5

6

7

8

Do not change bits 5 through 8.

(3)

Remove the rear cover, open the inlet cover of the saddle stitcher unit and tape the actuator of

inlet cover sensor (PI9) and inlet door switch (SW1).

(4)

Before inserting the paper, mark the top of the paper. You will be using two sheets of A3 or LD

paper.

Mark

A3/LD paper

Insert direction