Tally Genicom 5040 Manual Do Utilizador
Installation
User guide
8
Checking the printer
voltage
voltage
Make sure that the device has been set to the correct voltage (e.g. 230 V
in Europe, 120 V in the USA). To do this, check the type plate above
the power inlet at the back of the printer. Contact your dealer if the set-
ting is incorrect.
in Europe, 120 V in the USA). To do this, check the type plate above
the power inlet at the back of the printer. Contact your dealer if the set-
ting is incorrect.
Never switch on the printer if the voltage setting is incorrect,
since this may result in severe damage.
since this may result in severe damage.
Connecting the printer
Connect the power cable to the power inlet of
the printer. Connect the power cable plug to a
mains socket.
the printer. Connect the power cable plug to a
mains socket.
STOP
Type plate