Cognitive Solutions A799 Manual Do Utilizador

Chapter 4: Programming Commands

 81

Revision D 12/09

A799-PG00001D

This command is utilized in the TPG LogoEZ

®

 utility. The utility can be used to pre-configure new printers with a default 

colorization setup without requiring any application changes. The default setup was designed to provide a general level of 
colorization features that would not affect the printer operation. You can expand beyond the default features of the utility 
by modifying the application at the host. However, do not attempt to modify the settings within the utility.

 

f = 1:  s = 1H 

 

 

a = 30H

 

f = 2:  s = 32H 

 

 

r = 19H

 

f = 3:  s = 1H 

 

 

r = 7H 

 

 

t = 1H

 

f = 4:  s = 30H 

 

 

a = A0H

US EOT n 

Hexadecimal  1F 04 n 

31 04 n

Value: 

0 = Off 

 

1 = On

 

(When 0 and 1 are the LSB)

Default: 

0 (Off)

Selects or cancels 6-dot/mm emulation mode.
When the 6-dot/mm emulation is selected, logos and graphics are expanded horizontally and vertically during download 
to emulate their size on a 6-dot/mm printer. The horizontal positioning commands also emulate positioning on a 6-dot/mm 
printer.

US { n 

Hexadecimal  1F 7B n 

31 123 n

Value: 

0 = disable 

 

1 = enable

This command allows the firmware to determine 
the optimal speed to print a logo. It is set prior to 

downloading the logo and reset after the logo has been downloaded. 
In general, “Set max target speed (1D A0 nl nh)” is the preferred command.