Canon W6400 Manual Do Utilizador
6- 22
When You Cannot Print
Ejected Paper Is Blank
Problem1:
A blank page is ejected from the previous print
job.
job.
Solution1: The print job starts after the blank page is
ejected.
Problem2:
The leading edge of the roll media is cut to an
even length.
even length.
Solution1: When the roll was loaded, a plain cut sheet was
ejected as part of the normal procedure to align
the roll media correctly. When the preparation is
finished, the printer is ready to print.
the roll media correctly. When the preparation is
finished, the printer is ready to print.
Problem3:
Printhead nozzles are blocked.
Solution1: Print a nozzle check pattern to confirm the
condition of the printhead. If a nozzle is blocked,
perform the printhead cleaning procedure.
(
perform the printhead cleaning procedure.
(
Problem4:
An ink tank has run out of ink.
Solution1: Check the ink tanks and replace any empty ink
tanks. (
Problem5:
Printer is damaged.
Solution1: Contact a Canon service center.
Cannot Print on Network
Cannot Print from a TCP/IP Network
Problem1:
The LAN port and network cable are not
connected correctly.
connected correctly.
Solution1: Confirm that the connection of the cable that
connects the printer to the network is secure,
then press the Power button to cycle the printer
off and on again. (
then press the Power button to cycle the printer
off and on again. (
→
Problem2:
The printer cannot recognize automatically the
LAN communication method.
LAN communication method.
Solution1: Use the printer operation panel to select
Interface Setup > Ethernet Driver then set
each item for the communication method that is
being used on the LAN. (
each item for the communication method that is
being used on the LAN. (
Problem3:
The TCP/IP network is not set correctly.
Solution1: Confirm that the IP Address is set correctly.
(