ink (this is not unusual). It is not recommended
to execute Head Cleaning B unless after the
printer has been moved, after the printer has
been stored and not used for a long period, or
having problems with the printhead.

Problem3:

The printer consumes ink for the initial ink tank
filling.

Solution1: The first time the printer used after it is set up or

moved to a new location, the ink level display
may drop to as low as 80% as a result of filling
the printhead and ink tanks with ink (this is not
abnormal).

The message MTCart Full Soon does not go off
even after replacing a new maintenance cartridge.

Problem1:

The printer has not yet recognized the new
maintenance cartridge.

Solution1: Replace the maintenance cartridge and press

the Information button.

Solution2: After replacing a new maintenance cartridge the

message disappears upon executing a print or
cleaning operation.

Media is not cutting straight

Problem1:

The media is wrinkled at the cutting position.

Solution1: Flatten the media at the cutting position.

Power does not switch on

Problem1:

The power cord was unplugged with the printer
power on.

Solution1: Wait three minutes with the power cord

unplugged, then plug in the power cord again
and switch the printer on.

Roll media not inserted in feed slot

Problem1:

The roll media is curled.

Solution1: Insert either the left or right corner of the media

at a skewed angle into the feed slot, then
straighten the edge of the media so it is parallel
with the back of the printer.