Epson 3 Plus Manual Do Utilizador

POWER   DATA 

ERROR  

 

 

 

 

Flash data storage is complete 

 

 

 

 

Bad checksum of flash data 

 

 

 

 

No battery found when charging 

   

 

Time-Out 

when 

charging 

 

 

 

 

Low Thermal Head temperature 

 

 

 

 

High Thermal Head temperature 

   

 

Data 

Receive 

Error 

 

 

 

 

The printer is receiving no power.  If you are using the AC adapter, make 
sure it is connected properly.  See page 2, “Connecting to an AC Outlet.”  
Make sure the AC power outlet is “live.”  If you are using a DC adapter, 
make sure power is connected and that the fuse is good. 

 
 

If this indication occurs immediately when attempting to charge the battery, 
the printer did not detect a battery when you tried to initiate a battery 
charging cycle.  Make sure the battery has been installed and connected 
properly and that there are no broken wires at the battery or connector.  See 
page 36, “Installing the Battery.” 
 
If the battery is connected properly, you may have attempted to charge the 
battery and it has become overheated during the charge cycle.  An internal 
thermal breaker will open when overheated, and after cooling, will close 
again.  Allow the battery to cool before continuing to charge it.  If the 
problem occurs again, replace the battery. 
 

Page 54