Printek FormsPro 4300 Manual Do Utilizador

Page G-1

The following list describes conditions that are assumed whenever power is applied to the
printer, the SETUP mode is exited, or a reset escape sequence is received (when the printer is
operating in an emulation mode that supports such a sequence).

This list includes all variables that you can modify for all emulations, even though some
emulations cannot modify all of the variables shown.  Refer to the appropriate section of this
manual  for the emulation you are using.

Variable

Reset Condition

character pitch

according to current form setup

left margin

according to current form setup

right margin

according to current form setup

line pitch

according to current form setup

form length

according to current form setup

top margin

according to current form setup

bottom margin

according to current form setup

font

according to current form setup

impact mode

according to current form setup

language

according to current form setup

normal/slashed zero

according to current form setup

auto cut mode

according to current form setup

unidirectional mode

according to current form setup

top of form

set to current position

text in an incomplete line

discarded

input buffer

cleared (unless reset from host)

control of data bit 8

accepted as received

control character symbols

according to interface setup

italics

off

double high

off

double strike

off

double wide

off

emphasized

off

superscript/subscript

off

underline

off

horizontal tabs

to every eight columns

vertical tabs

cleared