Primera Technology LX900 Manual Do Utilizador

Adjust print alignment using the Status Monitor.  Go to the

Alignment Tab (third tab).  

Three items can be adjusted here:
•

. This value adjusts the position of the last

label printed after it has been presented for tear off.  This

only applies if the output mode is set to "Yes" Present the

label.  Add to the current value to move the tear point clos-

er to the printer.  Subtract from the current value to move

the tear point away from the printer. After adjusting the

value click the Set button to send the value to the printer.

•

. This value moves the printed label

left or right.  Add to the current value to move the printed

label to the right.   Subtract from the current value to move

the printed label to the left. After adjusting the value, click

the “Set” button to send the value to the printer. Note:

Before adjusting this value make sure the label stock is

properly loaded so that there is no gap between the edge of

the liner and the 

fixed throat guide

.  Any gap at this point

will greatly affect the Left margin offset value 

needed to align the label.  Also, if you adjust the value with

improperly loaded label stock you will have to adjust it

again if you load the label stock correctly the next time.

•

). This value moves the print start 

position up or down on the label. Add to the current value

to move the printed label down or toward the printer.

Subtract from the current value to move the printed label

up or away from the printer. After adjusting the value click

the “Set” button to send the value to the printer.

LX900.qxd  1/15/2010  8:00 AM  Page 33