Ricoh LDD280 Manual Do Utilizador
Troubleshooting
132
4
x Clearing Misfeeds
R CAUTION:
Note
❒ After clearing misfeeds, make sure
that all the doors, covers, and units
are closed and the x indicator is
off.
are closed and the x indicator is
off.
❒ To prevent misfeeds, do not leave
any torn scraps of paper, originals,
or masters in the machine.
or masters in the machine.
❒ When clearing misfeeds, do not
turn off the main switch. If you do,
your print settings will be cleared.
your print settings will be cleared.
❒ The master eject unit or the drum
unit may be locked if the security
mode is active. Enter the security
code or ask your administrator if
necessary.
mode is active. Enter the security
code or ask your administrator if
necessary.
❒ If misfeeds occur repeatedly, con-
tact your service representative.
“x + A” Paper Misfeeds in the
Paper Feed Section
Paper Feed Section
A
Remove the misfed paper.
-To prevent paper misfeeds:
Check the following before restarting
the printing run.
• Did you select an appropriate pa-
the printing run.
• Did you select an appropriate pa-
per type with [Feed Tray Paper
Type]
Type]
?
• Are the side pads in the correct po-
sitions?
To print on thin paper (47.1 g/m
2
,
12.5 lb), slide the levers behind the
paper feed side plates in the direc-
tion of the arrow (see illustration).
paper feed side plates in the direc-
tion of the arrow (see illustration).
• When paper is curled, correct as
shown.
• Be careful not to cut yourself on
any sharp edges when you reach
inside the machine to remove
misfed sheets of paper or mas-
ters.
inside the machine to remove
misfed sheets of paper or mas-
ters.
ZDCY140E
GRCURL0E