Ricoh 2018D Manual Do Utilizador
Using the Installation Shell Script
7
1
Note
❒ The IP address will be added to the /etc/hosts file.
❒ If the host name of the printer has already been configured, press the {{{{RE-
❒ If the host name of the printer has already been configured, press the {{{{RE-
TURN
}}}} ({{{{ENTER}}}}) key. Nothing will be added to the /etc/hosts file.
FFFF
Enter the printer's host name.
Enter Printer host name : nphost
Note
❒ The host name will be added to the /etc/hosts file.
❒ If no IP address was entered in step
❒ If no IP address was entered in step
, nothing is added to the /etc/hosts
file.
GGGG
Configure the printer name.
Enter logical printer name [default nphost_prn]
If you want to use the default name, press the
{{{{RETURN}}}} ({{{{ENTER}}}}) key. Enter
a new name if you want to use a different one.
Note
❒ The host name entered in step
followed by “_prn” appears in “default”.
HHHH
Set the print option.
Enter remote printer name [default lp]:
• Press the
{{{{RETURN}}}} ({{{{ENTER}}}}) key, and printing with PCL or PostScript 3
is enabled.
• If you want to set the device option, enter the option parameter.
Enter remote printer name [default lp]:tray=tray1
Reference
For more information about the device option, see p.19 “Specifying the
Device Option”.
For more information about the device option, see p.19 “Specifying the
Device Option”.
• If you enter “text”, text printing is enabled.
If you enter “text”, printing with PCL and PostScript 3 is disabled.
Enter remote printer name [default lp]:text
Limitation
❒ You can enter up to 14 characters for HP-UX 11.0, 256 for Solaris 8 and Red
Hat Linux 7.0, and 51 for Red Hat Linux 6.2.
❒ When printing with the “lp” command, use “_” instead of “=” and “;” in-
stead of “,” for operating systems that cannot use “=” and “,” such as So-
laris 2.5 or later.
laris 2.5 or later.
After setup with the installation shell script is complete, and if you entered
the IP address in step
the IP address in step
, the following message appears:
hosts file is modified