Kenwood KDC-U7056BTL Manual Do Utilizador
P.CONT
ILLUMI
REMOTE CONT
REMOTE INPUT
STEERING WHEEL
ANT.
CONT
MUTE
–
+
FR
ONT
SW
REAR
L
R
L
R
English | 13
Connecting wires to terminals
USB connector (0.8m)
To USB device.
If no connections are made, do not let the wire come out from
the tab.
the tab.
Blue/White
(Power control wire)
(Power control wire)
Blue (Antenna control wire)
Orange/ White
(Dimmer control wire)
(Dimmer control wire)
When using the optional power amplifier, connect
this wire to its power control terminal.
this wire to its power control terminal.
To car light control switch.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna,
or to the power terminal for the booster amplifier of
the film-type or short pole type antenna.
(Max. 300mA, 12V)
either to the control terminal of the motor antenna,
or to the power terminal for the booster amplifier of
the film-type or short pole type antenna.
(Max. 300mA, 12V)
Brown (Mute control wire)
To use the steering wheel remote control feature,
an exclusive remote adapter (not supplied) that
matches your car is required.
Light Blue/ Yellow
(Steering remote control wire)
(Steering remote control wire)
When connecting to the Kenwood navigation
system: Refer to your navigation manual.
system: Refer to your navigation manual.
Microphone (Accessory5)
(KDC-U7056DAB only)
(KDC-U7056DAB only)
USB maximum power supply current
: DC 5 V
: DC 5 V
= 1 A
B59-2188-10_01_13Stepup_QSG_M_En.indd 13
13/06/04 13:37