Lexmark MS312dn Laser Printer Manual Do Utilizador

Inches
Millimeters

Identify the units of measure.

Inches is the US factory default setting.

Millimeters is the international factory default setting.

3–8.5 inches
76–216 mm

Set the portrait width.

If the width exceeds the maximum, then the printer uses the
maximum width allowed.

8.5 inches is the US factory default setting. You can increase the
width in 0.01

‑inch increments.

216 mm is the international factory default setting. You can increase
the width in 1

‑mm increments.

3–14.17 inches
76–360 mm

Set the portrait height.

If the height exceeds the maximum, then the printer uses the
maximum height allowed.

14 inches is the US factory default setting. You can increase the
height in 0.01

‑inch increments.

356 mm is the international factory default setting. You can increase
the height in 1

‑mm increments.

Short Edge
Long Edge

Specify the feed direction if the paper can be loaded in either direction.

Short Edge is the factory default setting.

Long Edge appears only when the longest edge is shorter than the
maximum width supported in the tray.

Print a report containing information about the paper loaded in trays, installed
memory, total page count, alarms, timeouts, control panel language, TCP/IP
address, status of supplies, status of the network connection, and other
information.

Print a report containing printer statistics, such as supply information and details
about printed pages.

Understanding the printer menus

89