Konica Minolta 752 Manual Do Utilizador

 

3-2.Start-up Operation

 

6    DRYPRO MODEL 752 Operation Manual Ver.0.11 2002.6

 

3-2. Start-up Operation

 

Follow the procedure below to turn on the power of the equipment.

(1) Turn ON the power of the breaker located at the

lower-right of the device.

(2) Press the start switch below the control panel.

(3) The startup screen will appear.

(4) The WARMING UP screen will appear in approx. 2

minutes.

Breaker

Start switch

Pressing the start switch again turns OFF the
power. In this case, press the start switch again.

• Although printing cannot be made during

warming up, the data from the diagnostic
devices can be received. The received data
will be printed out after the device goes into
the READY status.

• Settings on the maintenance can be made

during warming up.

• It takes approx. 25 minutes for the device to go

to the READY status. Note that it depends on
temperature around the device.