KYOCERA FS-3820N Manual Do Utilizador

Indicators and Messages

4-10

Error Messages

The following table lists error messages that can be dealt with by the user. 

File not found
Press GO

VMB: A VMB tray that was specified for output does not contain any jobs, or the VMB 
tray is not being used. Confirm the VMB tray.
If Auto Continue is set to On, printing will be automatically resumed after a preset 

period of time. See 

Format error

Memory card

This message appears when the printer is in the ready state and the CompactFlash 
(memory) card is not formatted, and therefore cannot be read or written. Follow the 
procedure in 

 to format the card.

Format error

Hard disk

Initialization (formatting) of the Microdrive is required. Initialize the Microdrive. 
(See 

Hard disk err ##
Press GO

Look at the error code given in place of ## and refer to the corresponding description 

given below.
01: Microdrive format error. If this error recurs even if the power has been turned off 

and then on, reformat the Microdrive.

02: The disk system is not installed. Recheck the requirements for using the system 

and the devices.

04: There is no available Microdrive space. Delete unnecessary files, etc., in order to 

free up space.

05: The specified file does not exist in the Microdrive.
06: There is no memory available to the Microdrive system. Increase the available 

memory.

10: Formatting is not possible because host data is being spooled on the Microdrive.

Wait until the Microdrive is ready, and then format.

85: VMB; Alias error (the alias setting was lost, or the VMB tray corresponding to 

the alias does not exist). Set the alias again.

97: Code job; The number of permanent code job reached the limit value, and no 

more can be saved. Either delete some unnecessary jobs, etc., or increase the 
limit.

99: A print job for the specified ID does not exist in the Microdrive.

I/F occupied

This message is displayed when you attempt to use the printer’s operator panel to 
change the environmental settings on the interface from which data are presently 
being received.

ID error

The ID entered for a private job, or a stored job is not correct. Check the ID that is set 
using the printer driver.

Insert the same
memory card

You have inserted the wrong CompactFlash (memory) card when the Insert again 

message was displayed. Remove the wrong CompactFlash card from the printer’s 
CompactFlash card slot and insert the correct CompactFlash card. The printer again 
reads it from the beginning of the data.

KPDL error    ##
Press GO

Current print processing cannot continue. To print out an error report, display > 
Print KPDL errs from the mode select menu, and select On. Press the GO key to 

resume printing. You can abandon printing by the CANCEL key.
If Auto Continue is set to On, printing will be automatically resumed after a preset 

period of time. See 

:Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.

;Ò

;Ò

;Ò

;Ò