KYOCERA FS-3820N Manual Do Utilizador
Interface
1-78
Network Interface Parameters
This printer supports TCP/IP, NetWare and EtherTalk protocols. In
addition, you can install the option network interface card in the option
interface slot.
Using the operator panel, you can:
• Activate or deactivate TCP/IP, NetWare, and EtherTalk
• Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
To confirm or change network card parameters, proceed as follows:
Using the operator panel, you can:
• Activate or deactivate TCP/IP, NetWare, and EtherTalk
• Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
To confirm or change network card parameters, proceed as follows:
1
Press the MENU key.
2
Press the or key repeatedly until Interface > appears. One of
the interface names shown below appears, indicating the current
interface.
Parallel (default)
USB
Network
Serial (when a serial interface board kit is installed)
Option (when a network interface card is installed)
USB
Network
Serial (when a serial interface board kit is installed)
Option (when a network interface card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
If the option network interface card is installed in the printer,
Option will be displayed. The setting procedure is basically the
Option will be displayed. The setting procedure is basically the
same even in this case.
4
Press the or key repeatedly until Network appears.
5
Press the ENTER key again.
Interface
? Parallel
? Parallel
Interface
? Network
? Network