Savin SLP38C Manual Do Utilizador

Paper Recommendations

53

❖

❖

❖

❖ Thick Paper

• Use the Bypass Tray.
• The Bypass Tray can hold paper up to 135 kg (163 g/m

2

) in weight. The

print quality on paper that is thicker cannot be guaranteed.

• Confirm that the top of the stack is not higher than the limit mark inside

the tray.

• When printing on thick paper, select thick paper mode with the printer

driver.

• When printing on the reverse side of plain paper that is already printed on,

you should load it on the Bypass Tray and select [Thick (Duplex Backside)]
from [Paper Type:] with the printer driver.

❒ The number of sheets to be set may vary depending on the paper thick-

ness and paper type.

❖

❖

❖

❖ OHP transparencies

• When printing on OHP transparencies, use the Bypass Tray.
• Load OHP transparencies on the tray with the print side over or they may

stick to the Fusing Unit and cause a misfeed.

• Remove any unused OHP transparencies from the Bypass Tray after you

are finished printing. Leaving them in the tray may cause them to stick to-
gether.

• When printing on OHP transparencies, you should select the OHP trans-

parency mode with the printer driver.

• The Bypass Tray can hold up to 100 OHP transparency sheets. 
• Confirm that the top of the stack is not higher than the limit mark inside

the tray.

• When you print OHP transparencies more than one copies, remove each

sheet from the tray one by one before next sheet is printed out, or select
"Slip Sheet" in the printer driver. For details about using "Slip Sheet", see
the printer driver Help file.