Savin 1232 Manual Do Utilizador

Error & Status Messages on the Display Panel

29

Following output tray is full. 
###

The indicated output tray is full.

❒ “###” in the message rep-

resents a output tray.

Remove the paper.

HDD has a problem.

An error has occurred in the 
hard disk drive.

Turn off the main power 
switch, and on. If the message 
appears again, contact your 
sales or service representative.

HDD has not been installed.

The Locked Print was per-
formed without the hard disk 
installed, or the hard disk is 
damaged.

Install the hard disk if not in-
stalled. If the message appears 
again after the hard disk is in-
stalled, contact your sales or 
service representative.

HDD is full.

The maximum hard disk area 
size for form/font has been ex-
ceeded.

Delete unused form/font 
types.

An HDD overflow error oc-
curred during Sample Print or 
Locked Print.

Delete stored files or reduce 
the file to be downloaded.

IEEE 802.11b (Wireless LAN) 
has a problem.

IEEE 802.11b card was not in-
serted when the machine was 
turned on, or it was pulled out 
after the machine turned on.

Turn off the machine and 
check the IEEE 802.11b card is 
inserted correctly. Then, turn 
on the machine again. If the 
message appears again, call 
your service center.

I/O buffer overflow.

The maximum size of the I/O 
buffer has been exceeded.

Increase the size of the I/O 
buffer.

LCT has a problem. Turn 
Main Power Switch off then 
on. If the error appears again, 
call service representative.

An error occurred in the large 
capacity tray.

Turn off the main power 
switch, wait five minutes, and 
on again. If the message ap-
pears again, call your sales or 
service representative.

dLower Staple is almost 
empty.

There are a few staples re-
maining in the lower stapler.

Load in more staples.

NV-RAM has a problem.

An error has occurred in the 
optional memory unit.

Turn off the main power 
switch, and on. If the message 
appears again, call your sales 
or service representative.

Output tray has been 
changed.

The output tray has been 
changed automatically.

Select the proper output tray.

Paper in duplex unit. Open 
cover and remove paper.

There is a misfeed in the du-
plex unit.

Open the cover of the duplex 
unit, and remove the misfed 
paper.

Paper in staple tray. Open fin-
isher cover and remove paper.

There is paper remaining in-
side the finisher.

Open the cover of finisher, and 
remove the paper.