Zebra Technologies P1013372-001 REV. A Manual Do Utilizador
Installation and Setup
Connecting Power
P1013372-001 Rev. A
Zebra ZXP Series 8 Card Printer with Laminator
31
Connecting Power
Step 1.
Place the Printer’s power switch in the OFF (
) position.
Step 2.
Depending on your local AC voltage, plug the appropriate power cord into the
Printer’s power connector and a grounded AC power source connection.
Printer’s power connector and a grounded AC power source connection.
DO NOT SWITCH THE PRINTER ON (
).
Electric Shock Caution • Limit AC power supplied to the Printer to 100 – 230 volts,
60 ~ 50 Hertz. Limit excess current draw to 16 amps or less, using an associated circuit
breaker or other such device.
60 ~ 50 Hertz. Limit excess current draw to 16 amps or less, using an associated circuit
breaker or other such device.
Never operate the Printer in a location where operator, computer, or printer can get wet.
Personal injury could result.
Personal injury could result.
The Printer must be connected to an earthed electrical power source and properly
protected against electrical surges and grounding faults; the electrical reliability of the
Printer is based on the reliability of the mains power source and with the earth
connection.
protected against electrical surges and grounding faults; the electrical reliability of the
Printer is based on the reliability of the mains power source and with the earth
connection.
The Printer’s power supply is an internal unit that can only be serviced or replaced by
trained and authorized personnel.
trained and authorized personnel.
✓
1
2